Typical Applications
› Typical Applications

› Best applications

› Applications that may not be ideal, but might still make sense

› Applications that are generally poor



Some of the rubber and foam parts shown here are used in the construction of OMAX machines


Job Shops: Produce a wide variety of short-run parts

Wire EDM Shops: Save valuable machine time where ±0.001" is acceptable (2626|xp)

Laser Shops Aerospace Industry: Work with materials that are affected by heat such as titanium, and aluminum

Prototype and R&D Shops: Work directly from CAD drawings

Maintenance and Repair Shops: Quickly produce one-off parts

Original Equipment Manufacturers: Control Just-in-Time inventory requirements

Metal Fabricators: Offer “clean edge” plate work, such as brackets, machine parts and weldments Architectural

Fabricators: Lets you create complex designs in glass, stone, tile and metal Abrasivejet

Specialty Shops: Makes parts with higher tolerance than any other abrasivejet system

Industrial Manufacturing: Minimize scrap when working with expensive materials



 

Address: 21409 72nd Ave South, Kent, WA 98032 | Telephone: 1-800-838-0343 or 253-872-2300
Fax: 253-872-6190 | Email: OMAX@OMAX.COM | Privacy Policy