Factory Inspection

OMAX JetMachining Centers are completely cleaned and prepared for resale.
Manufacturing evaluates the condition of each machine and replaces components as required.

• Disassemble the XY axes to clean and refurbish
• All debris is removed from the machine
• All surfaces are cleaned and scrubbed
• Tank is sandblasted and recoated
• Replacement of damaged or worn items are installed
• The ball screw is checked, cleaned, and greased
• All linear drives are tested and reviewed
• Control servo drive systems are tested
• Bellows are thoroughly inspected, repaired, or replaced
• All controllers are loaded with current OMAX Intelli-MAX^® Software
• Controllers are upgraded to current configuration
• All machines are retested for accuracy
• A Reinshaw Ballbar test is conducted
• A laser test is conducted to verify squareness on large machines

OMAX Direct Drive Pump

• The complete wet end assembly is cleaned and checked
• All worn or damaged parts are replaced
• Crank case is replaced if the pump has ran more than +3000 hours
• Standard functional testing is conducted