Accessories:

› Accessories Home

› Tilt-A-Jet® (tiltable Z-axis)

› New! Terrain Follower

› Precision Optical Locator (POL)

› Motorized Z-axis

› Adjustable Tilt Nozzle

› Drill Head Attachment

› MAXJET™ 5 Nozzle

› MiniJet Nozzle

› Bulk Abrasive Delivery Systems

› Solids Removal System (SRS)

› Settling Weir

› Waterjet brick

› Chiller Systems

› Closed Loop System (CLS)

› Reverse Osmosis System (ROS)

› Step Up Transformers




A prototype linkage arm for the Tilt-A-Jet®
Drill head attachment

OMAX Drill spec sheet (PDF) [550 Kb]

The OMAX Drill Attachment permits reliable piercing of laminate and composites prior to abrasive waterjet cutting.

The OMAX Drill accurately pierces small diameter holes in thick material.


Reliable piercing of composites and laminates




The OMAX Drill Head Attachment is mounted to the Y-Axis Carriage.


Standard Features
  • One-fourth horsepower, totally enclosed fan cooled 90 Volt D.C. motor. Motor controller requires 110 VAC single-phase power.
  • Motor, direct drive to spindle is fully adjustable to a maximum of 6000 RPM at the drill bit.
  • Drill is equipped with a 1/16" diameter collet (maximum size collet is 1/2")
  • Fully-adjustable pneumatic feed with up to 3 inches of travel and 300 lbs. of thrust with 100 psi air.
  • Automatically controlled by OMAX PC-based control system
Note: The Drill Attachment may reduce X,Y, and Z travel slightly. Contact OMAX for specifics.
 

Address: 21409 72nd Ave South, Kent, WA 98032 | Telephone: 1-800-838-0343 or 253-872-2300
Fax: 253-872-6190 | Email: OMAX@OMAX.COM | Privacy Policy