This piece was made from 8" (200mm) thick aluminum as a demonstration of what an abrasivejet can do.

Drill Head Attachment


OMAX Drill spec sheet (PDF) [550 Kb]

Reliable Piercing of Composites and Laminates



The OMAX Drill Attachment permits reliable piercing of laminates and composites prior to abrasive waterjet cutting. The OMAX Drill is mounted to the Y-axis carriage (same side as Z-axis).

The OMAX Drill accurately pierces small diameter holes in laminates and composite material.





The OMAX Drill Head Attachment shown with a Tilt-A-Jet option


Standard Features

  • One-fourth horsepower, totally enclosed fan cooled 90 volt DC motor. Motor controller requires
    110 VAC single-phase power.
  • Motor, direct drive to spindle is fully adjustable to a maximum of 6000 RPM at the drill bit
  • Drill is equipped with a collet holder and 1/16" collet. Maximum size of collet available is 1/4" for the supplied collet holder. Other collet holders are available for up to 1/2" collet.
  • Fully-adjustable pneumatic feed rate and depth of feed up to 3-inches of travel and 300 lbs.
    of thrust with 100 psi air
  • Automatically controlled by OMAX Windows® PC-based control system
Note: The Drill Attachment may reduce X,Y, and Z travel slightly. Contact OMAX for specifics.

Address: 21409 72nd Ave South, Kent, WA 98032 | Telephone: 1-800-838-0343 or 253-872-2300
Fax: 253-872-6190 | Email: OMAX@OMAX.COM | Privacy Policy